H2-ERM and H4-ERM User Manual

Important Note:
You will need the ERM Workbench software tool. Click here to download the software at no cost.

PDF Document View / Download the Complete Manual

Click the link above to view the complete manual. Individual chapters and appendices may be downloaded below.

Manual Contents
PDF Document Table of contents
PDF Document Revision History (Current version is 2nd Edition, Rev. E - Nov. 2024)
PDF Document Important Safety Warning

Chapters
Chapter 1 PDF Document Introduction
Chapter 2 PDF Document ERM / Slave Network Addressing Modes
Chapter 3 PDF Document Installation and Network Layouts
Chapter 4 PDF Document Configuring the ERM and Slave Modules with ERM Workbench
Chapter 5 PDF Document Using NetEdit
Chapter 6 PDF Document Maintenance and Troubleshooting

Appendices
Appendix A PDF Document General Specifications
Appendix B PDF Document ERM / Slave Diagnostics and Error Codes
Appendix C PDF Document ERM and ERM Workbench Default Settings
Appendix D PDF Document Mapping ERM Slave I/O in a Think & Do WinPLC System
Appendix E PDF Document Configuring Terminator Analog Output Modules
Appendix F PDF Document H2-EBC(100) Analog Module Addressing